Uncompromisingly good edges
The TruTool TKA 1500 is equipped with a powerful and robust 2600 W motor, which at the same time will impress you with its extremely low noise level and enable you to work without getting tired. The resulting stable machine guidance in combination with the ergonomic guide and motor handle also has a positive effect on the chamfer quality. You can create chamfer lengths of up to 15 mm and fix them in a continuously adjustable manner and without tools. The result: high-quality, repeatable edges right away – without rework. With the TruTool TKA 1500 you can create clean visible edges, break off sharp edges, add a radius or prepare a weld seam. Any oxidation or deformation of the material is avoided.
Ergonomic operation
The handle shape, size and positioning are perfectly matched to each other. This not only ensures safe machine guidance, but also supports the chamfer quality.
In the blink of an eye
Chamfer lengths can be set as required without the need for any tools, with a max. ¾ manual turn. In this way, you have a clear view of the dial ring
Consistent edge quality
High-quality results with burr- and oxide-free surfaces, without material change and at a constant angle adjustment.
Versatile use
For straight edges, inner and outer contours and holes from 80 mm.
Simply get started
The stop prism ensures easy run-in to the sheet metal for straight sheet metal and when processing outer contours.
2 in 1
At the same time, the stop prism acts as chip protection. The chips fall on the floor in a controlled manner, ensuring a high level of occupational safety.
Dimensional drawing - TruTool TKA 1500
This is speed
TruTool TKA 1500 is equipped with a powerful motor with a low noise level. This allows you to create chamfer lengths of up to 11 mm in one operation. For chamfer lengths from 11 mm to 15 mm, two steps are required. For example, a 15 mm chamfer length can be produced by achieving 11 mm in the first operation and the rest in step two (information for the 230 V motor)
Long service life
We offer high-quality multi-edge cutters and radius multi-edge cutters for a wide range of materials. Standard multi-edge cutters have four cutting edges. In contrast, radius multi-edge cutters have three cutting edges.
With or without
The TruTool TKA 1500 is delivered with the 45° multi-edge cutter mount as standard. You can also purchase the machine without tools and choose the 30°, 37.5° or 60° multi-edge cutter mount or the radius multi-edge cutter mount to suit your application.
Simply get started - and work without chips
The high-quality stop prism is made of stainless steel and ensures optimal machine guidance and easy run-in to the sheet metal. This applies when you are processing straight sheet metal and outer contours. In addition, the stop prism also serves as a practical protection against chips and the chips fall to the floor in a controlled manner. This also increases safety in the workplace.
